Light Status on Linksys Triband Ac4600 Intelligent Mesh WiFi Router

The Velop ac4600 provides a stunning feature for its consumers so that they get all the working status of the system. Each node of the Velop wifi system has an Led light that blinks to indicate the performance of the nodes. In this setup process you will read that How to Reset the Velop ac4600 in easy mode.

Blue - i)It blinks to indicate that the node is powering on

         ii)When constantly lighting, Node is online

Purple - i)It states that the node is ready for set up

             ii)It blinks to state that the set-up process is in progress

Red - i)It indicates that the node is not receiving any internet connection

         ii)If blinking, it indicates that the node is not connected with the other nodes properly.

Yellow or orange - It indicates that the node network strength is weak.

How to Reset the Velop ac4600 wifi mesh to factory defaults?

Resetting the Velop ac4600 wifi mesh means reverting it to the default setting when it was first taken out of the box.

Make sure that the blue or purple light is showing up before you can reset the node.

* Check if the first node is connected to a modem and is turned on.

* The reset button will be on the bottom side of the device. Press and hold the button until the node shows the red light.

It will disconnect the other nodes from the first node.

* Apply the above steps on the other nodes to reset them also.

How to Update the Firmware of triband ac4600 Velop system

Updating the firmware of the Velop ac4600 wifi mesh keeps the system performance smooth and fix different issues.

Updating the firmware using the Linksys app

* Install and open the Linksys application on your device

* Enter the username and password to log in to the app and access the velop dashboard

* Click on Network administration on the upper left side of the screen after opening the menu

* Tap update available to update the firmware if there is any update available.

* Wait till the status light is turned blue.

Note: If you have enabled auto-update, it will update the required nodes when available automatically.

Updating the firmware using the web interface

* Launch a web browser on the computer which is connected to the Velop's wifi.

* Go to router settings and select connectivity

* Tap update available to update the firmware if there is any update available.

* Wait till the status light is turned blue.

Linksys velop ac4600 Review

The velop ac4600 provides you a great coverage area that allows you to freely use the wifi sitting anywhere in your house or office.

Some consumers of the Velop mesh wifi are facing problems with the scheduled access feature of the device. A common issue of the consumers is that the nodes are not coming with front or bottom protective film. You can also connect two devices with the two ethernet ports on the remote node. For more information we are available on linksys wifi extender setup. You can get connected with us and avail the benefits of our information.